Anyone living in the UK is probably familiar with
the old style BT telephones. The first versions date back to the early 1920s
when you rented the handset from BT (then known as the GPO) and had it
hard-wired into your house.
This cream Bakelite version is part of the 700
series made from 1959 to the late ‘80s. I found it languishing at the bottom of
a tea chest in an old house my parents are renovating, aside from the copious
amount of dust covering it it seemed to be in relatively good condition so I
took it home to clean it up. This is what it looked like when I first uncovered
it:
I started by unscrewing the case and lifting it
away from the base. I took the speaker and microphone out of the handset and
using a pair of pliers, twisted and pulled the flex free. I managed to remove
most of the dirt from the Bakelite components by washing them in hot soapy
water. I read online that liquid metal polish can be used to remove ingrained
grime and restore the original shine, so I liberally applied Brasso with an old
household sponge, left it to dry to a film before buffing it off with a soft
cloth. If you use this technique yourself I strongly recommend doing it in a
well-ventilated area (preferably outside) or investing in a gas mask. I
foolishly did it on the kitchen table and nearly passed out from the noxious
fumes. After much polishing it did leave the case clean, smooth and shining
like new though.
Next I had to unwire the line in and line out cables
from the base unit. Faced with a bewildering mass of tiny wires I drew a quick
diagram showing exactly what went where before disconnecting them. I dusted the
electronics carefully with a paintbrush and a soft cloth. Cleaning the cables
presented a bit more of a challenge, while the straight line in cable was
pretty simple –I just held it taught and rubbed it with a lightly abrasive
scouring pad- I didn’t want to risk pulling the curled cord out of shape so I
used another tip I found online, submerging it overnight in a solution of warm
water and biological detergent. When I rinsed it off in the morning it came out
brilliantly clean.
I tackled the dial next. Not only was it covered
in dust but it was running slowly so I removed the cover with a piece of tape,
dismantled the dial and lubricated the turning mechanism. Bakelite Gal’s blog http://antiquephones.blogspot.co.uk/ was
invaluable in explaining the whole process clearly and simply. I cleaned all the
plastic dial components although the original paper dial label was beyond
saving so I created a new one based on the original design (yes, it does match
my blog!), resized it and printed it on lightweight card. I then reassembled
the whole dial, rewired the electronics and slotted the case back into place.
This is how the finished phone looks. Although I
can’t help but be a little disappointed that it came out more of a vanilla
creamy shade rather than ivory/off white I’m still really happy with it. What do you think?
